Jiangsu ANDE Precision Bearing Technology Co., Ltd. · Blog

Bearing Industry Insights & Guides

Industry insights, procurement guides, and technical knowledge for bearing professionals.

Bearing Internal Clearance: C2 to C5 Classes & Chart

Radial internal clearance grades bearings from tight C2 to loose C5 (ISO 5753-1). See the micrometer bands for a 50 mm bore and how fit and heat cut operating clearance.

Jeff Li

Technical Knowledge2026-08-1016 min read

Miniature Bearings: Sizes, Numbering & Selection

A miniature bearing has an outside diameter around 10 mm or less, down to a 0.6 mm bore. Decode the metric MR and inch R numbering systems, and choose material, ABEC precision, and clearance with confidence.

Jeff Li

Technical Knowledge2026-08-0918 min read

Thin Section Bearings: Types, Sizing & Mounting Guide

A thin section bearing has a radial section under a quarter of its bore. Learn the two families sold under this name, types C, A and X, and the mounting fits that decide survival.

Jeff Li

Technical Knowledge2026-08-0515 min read

How to Read a Bearing Number: Decode Any Designation

Decode any bearing number in three parts: type, size, suffix. The last two digits × 5 give the bore. What 6205, 2RS and C3 mean, plus a cross-brand suffix chart.

Jeff Li

Technical Knowledge2026-07-2816 min read

Needle Roller Bearings: Types, Load Capacity & Selection

Needle roller bearings carry 2–8× the load per unit mass of other types at half the OD. Full guide to the four families, designations, and how to choose.

Jeff Li

Technical Knowledge2026-07-2314 min read

Bearing Lubrication: Grease vs Oil, Intervals & Film Data

Poor lubrication causes 36% of premature bearing failures. Complete guide to grease vs oil, fill %, relubrication intervals, and the film ratio (λ) that sets bearing life.

Jeff Li

Buying Guide2026-07-1015 min read

Top Bearing Manufacturers in 2026: Ranked by Revenue

The world's largest bearing manufacturers ranked by revenue — SKF leads at ~$9.3B FY2024. Plus China's real players and how to qualify a supplier.

Jeff Li

Technical Knowledge2026-07-0115 min read

What Is an Angular Contact Bearing? Contact Angles & Selection

Angular contact bearings carry combined radial + axial load at a set contact angle (15°–40°) and mount in pairs — DB, DF or DT. Full selection guide.

Jeff Li

Technical Knowledge2026-06-2514 min read

What Is a Flange Bearing? Types, Codes & How to Choose

Flange bearings mount perpendicular to the shaft. Decode UCF/UCFL/UCFC codes, size the bore (last 2 digits x 5 mm), and choose flange vs pillow block correctly.

Jeff Li

Need expert advice on bearing procurement?

Our engineering team provides free technical consultation for bearing selection, sizing, and application optimization.

Bearing Internal Clearance: C2 to C5 Classes & Chart

All Articles

Miniature Bearings: Sizes, Numbering & Selection

Thin Section Bearings: Types, Sizing & Mounting Guide

How to Read a Bearing Number: Decode Any Designation

Needle Roller Bearings: Types, Load Capacity & Selection

Bearing Lubrication: Grease vs Oil, Intervals & Film Data

Top Bearing Manufacturers in 2026: Ranked by Revenue

What Is an Angular Contact Bearing? Contact Angles & Selection

What Is a Flange Bearing? Types, Codes & How to Choose

Need expert advice on bearing procurement?